Mustang Upholstery Part III

Sorry it’s been more than a couple days…a week plus actually.  But hey, it 115 degrees in my garage.

So I removed the seat and inspected the underside.

Again this was my first upholstery job, ever.  So removal of the old upholstery on this first seat was a learning experience so I didn’t get too many shots.

Here is a shot of the seat out of the car.

Seat Out

You have to remove the plastic covers for the hinges and the rest of the hardware to separate the bottom from the back.

Just a couple of screws to remove the covers, hinges and hardware

Here is the underside of the seat with the track hardware still attached.

Back removed the track still in place.

The track is remove with 4 star bolts.  Be careful use the proper socket, I happened to have just purchased a huge set of tools (a bit more the ‘average guy’ might have) that had the necessary socket set.  If you don’t have those, find one of those universal sockets that ‘form’ to bolt.

4 star bolts hold the track to the frame of the seat bottom

Bolt and socket

Part IV coming up tomorrow.

Thanks for reading

Tim