Update on Transmission for Project SportsRoof – ’73 Stang

Spend a few hours on this 2017 Labor Day, laboring over #ProjectSportsRoof and I wish that labor paid a bit more dividends.

The goal was to mate the transmission back to the engine but unfortunately that just wasn’t going to happen today.  The engine is set back a bit too far and tilted (on purpose).  Problem is if I bolted them up the engine hoist would be able to lift the engine and trans due to the height I needed the car to work on the transmission.

So I pulled the transmission out from under car and placed its wheels back on the concrete.


It was a major effort to get the car up high enough to get the transmission out.  I pushed the boundaries of safety with a floor jack and a couple of jack-stand.

As I stated in the video I may just take it down the street and have them get that straightened out for me.

More to come on #ProjectSportsRoof.

Thanks for reading.



1973 Mustang Project SportsRoof – Exterior Walk-Around

Welcome back to #ProjectSportsRoof.  I run my car projects much like I run my IT projects.  You always have to know where to start and know the end game.   As with any project that isn’t being built from scratch, in other word, you have to work with what you’ve got, …
1973 Mustang – Engine Bay Work

If you look back at #ProjectSportsRoof post you’ll see the condition engine bay.  During those videos I mentioned that I was going to clean it up and hit it with a rattle can.  Again this isn’t going to be a concours restoration, it’s going to look nice and it’s going …
1973 Mustang – Project SportsRoof – Compression Test Part II

This is the wrap up on the compression testing for the 1973 Mustang w/ a 1972 351 Cleveland power plant. You’ll might have notices that I referred to the remote tester, which is my code for remote starter…yeah…that’s it!!! All of these tests were dry test and I should have done a …
Tagged , , , , , , , , . Bookmark the permalink.

One Response to Update on Transmission for Project SportsRoof – ’73 Stang

  1. Bill says:

    I have a hoist you can borrow if you want to try to loosen the motor and get the transmission installed.

    I know pulling a transmission without a lift is very difficult.

Let me hear from you!!! Drop a note!!