Mustang Upholstery Part II

The next step is to remove the seat from the car.

For the Mustang the studs pass through the track and the nuts are under the car so a little space is need.  Since most average guy’s don’t have a lift in their home garage, so I pull out the trusty 2 ton floor jack and a jack stand.

As most Mustang owners know, they were built with subframes.  When jacking up the car with a floor jack place it on the frame, or use the standard scissor jack that attached to the seam at the rocker panel.  Either way once it’s in the air, DO NOT FORGET to put the jack stand under the car. Yes it actually takes longer to do the set up then to remove the bolts…but take the time to be save.

2 Ton Floor Jack

Floor pan plug that protect the bolts and studs.

These plugs pry out very easily.  I was able to get them out with just my fingers.  Once they are removed you’ll have access to the nut.  The distance between the opening and the nut requires an extension and the length of the stud requires a deep socket.  These were 1/2″.  The Mustang was raised in Arizona (get it?  First reader to drop a comment explaining “get it” wins a DVD.)  and all the plugs are in place.  This kept all the road grime and what not off the studs and nuts, they separated easily.

When you are done you should have this many parts.

When I purchased the Mustang I was told that the upholstery was replaced at some point. (Keep that in mind for later as well.)

[vodpod id=Video.11743606&w=425&h=350&fv=file%3Dhttp%253A%252F%252Fvid299.photobucket.com%252Falbums%252Fmm296%252Ftimsweet2200%252Fremoval1.mp4]

 

As you can see in the video I wasn’t able to get the seat out of the car. I initially I figured it was because I couldn’t pull out level enough for the studs to clear the holes due to the fact that I was holding the camera. However, after putting it down I still shouldn’t get the seat out. So I climbed back under the car and found that there was a second nut on the right rear stud. I’m guess it was doubled up, when the last installer wasn’t sure whether they already but one on? And of course you can see by the previous picture that those two nuts not the same as the others.

Part III will be coming up in a day or so.
Thanks for reading.
Tim

Tagged , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , . Bookmark the permalink.

Let me hear from you!!! Drop a note!!