Mopar Door Panel Project – The LeBaron Part 2

Let’s finish up the coverage of this project.

As you as in the Part 1 we ran into some issue with the clue holding on some critical parts of the door panel, like the part that holds up on sub-panel that holds the controls for the window, locks and mirror remote.  Also needing attention was the vent channel that push air to driver’s window to defog it.

I wanted this fixes to be permanent and it was clear that more glue wasn’t going be a long-term fix.  There isn’t much that makes up the door panel, it was only about 1/4″ thick. Now I know it might make folks cringe, but it was necessary, I used very small (short) hobby screw.

Here are some pics:

This first pic is showing the actual problems.

PANEL2The two “A”s are showing the two clips on the back of the brace that accept the male part of the clip from the panel that holds all the controls.  Without begin attached the back of the door panel the control flop around and slide out-of-place.

The “B” and arrow highlight the issue.  There the glue let go and you can see the gap.

IMAG1691

Here you can see the vent channel.  This posed a bit of an issue because the door panel is thin here and on the outside there is a locking ring that is mainly a decorative actually had locking prongs, which as a result of the glue no longer holding fast, broke off and I had to JB Weld them back on.  In this pic you can see one of the screws I used to put every thing back together.

IMAG1684

Here is a close up of the one of the screws.  In the lower left you can see on of the blobs of glue that came loose.

This was a really easy repair, however, we didn’t resolve the window issue.  So we’ll pull the right side door panel and see if we can fix window issue and as long a we’re in there we’ll shore up the braces.

Thanks for reading.  Leave a comment.

Tim

Tagged , , , , , . Bookmark the permalink.

One Response to Mopar Door Panel Project – The LeBaron Part 2

  1. Bill says:

    The trim ring that hold the side defrosting pipe was still available from Chrysler as of a few years back. These trim rings have been replaced several times over the past 20 years.

    I hope the screw holds. There is not much material to bit into. Perhaps a decorative trim screw from the other side with a locknut might work?

    I’ve actually made a similar repair on a Aerostar door panel using hot melt glue that held up
    well.

    I’ll be happy to troubleshoot the window problem.

    Merry Christmas

Let me hear from you!!! Drop a note!!