73 Mustang Heater Box Part 6 – Fiberglass Work

Thanks for checking back in on #ProjectSportsRoof.  If you recall there was a lot of damage to the heater box, but rather than purchase a new one I opted to see if I could repair this original.

As of this post I’ve cleaned up the box and used JB Weld to put the pieces back in place and I’m ready to apply some fiberglass to harden everything up.

Here is a look at the fiberglass work.


What’s coming up next on the heater box work is a good look at the kit that you can buy that has some of the rubber seals, clips and replacement pads for the internal air flow doors.  We are going to install those and but the box back together.  I know you are on the edge of your seat for that one.

Thanks for reading.

Tim

1973 Mustang – Project Sports Roof – Fender Fitment Part II

In these next two videos, you’ll see just how ‘off’ these fenders are in some areas and surprisingly how well they fit in other areas. If you have an experience or a hit for anyone taking on this part of a restoration – drop a comment here and we’ll share them. https://youtu.be/Ga9EHbDpSfg     https://youtu.be/FBKs7EG4kK0   Thanks …
Average Guy’s Car Restorations, Mods, and Racing

I know…it’s a bit of let down moving back to the heater box for # ProjectSportsRoof when the beautiful 351 Cleveland that’s going to power the 73 Mustang is …
351C Removal and tear down – YouTube

Jul 19, 2016 Welcome back to #ProjectSportsRoof. This the beginning of rebuild of the 351 Cleveland for the 73 Mustang.

 

Tagged , , , , , , , , , . Bookmark the permalink.

One Response to 73 Mustang Heater Box Part 6 – Fiberglass Work

  1. Bill says:

    Great tip on the resin mix in a milk jug; I love the Tupperware comment.
    Have you pulled a vacuum on the evaporator?

Let me hear from you!!! Drop a note!!