1973 Mustang SportsRoof – Floor Pans Getting To It! – Part Two

Hey, welcome back to #ProjectSportsRoof (1973 Mustang).  We are working through the rusted floor pans and I’m about to make the cut for removing rust from the right rear foot-well.

Quick note about the video sequence.  As executive director, camera guy (well smart phone guy) and film editor (is that still a real thing?), I don’t always plan out the steps like you might see on a TV show.  (There goes my chances of being on Counting Cars – I’ve got a better chance of being a walk-on-the-set zombie on the Walking Dead – I love both of those shows!!!! ) Perfect example is in the next few posts and videos.  Instead of stripping out all the carpeting, I made a cut along the tunnel on the right side and just removed that carpet.  You can clearly see that.   Then I removed the rust from the foot-well (you’ll see that below) and then worked on cutting the re-pop floor patch.

That went so well, I felt confident enough to remove the driver’s seat and the rest of the carpeting.  So when I show that video you’ll notice both patch panels on the right side are fitted.  There just no ‘do overs’ on this project.

Here are the next two videos.  By the way you can see all the videos on my YouTube channel  just search for #ProjectSportsRoof and you’ll find most of them.



Once again in the video I mention getting the replacement pan for under the rear seat – above the muffler.  However, as I mentioned previously that portion of the floor is not reproduced.

More floor panel work coming up.  If you have comments or tips/hints use the comment box below.  Love to hear from you.

Thanks for reading.



Out and About!!! #ProjectSportsRoof

Out and About!!!







1973 Mustang – Project SportsRoof – Compression, Rods and Heads

Thanks for check in on #ProjectSportsRoof. If you remember a of couple months back, shortly after bringing the ’73 Mustang home, I conducted a compression test on all the cylinders.  The 351C was running rough (to put it mildly) and smoked like a pile of tires on fire (only the smoke …



Tagged , , , , , , . Bookmark the permalink.

2 Responses to 1973 Mustang SportsRoof – Floor Pans Getting To It! – Part Two

  1. Bill says:

    Well I’m impressed. No air chisel, just a Dremel.
    Time for some POR15!

    • Tim Sweet says:

      Since I’m behind on the blogging, it’s already done. I used Eastwood Black Rust Encapsulator, then I coded with spray truck bed lining.

Let me hear from you!!! Drop a note!!