1973 Mustang – Project Sportsroof – Leaks, Pertronix & Leaks! Part III

Thanks for checking back on the #ProjectSportsRoof progress.  Wrapping up the Pertronix install, I’ll had an issue.  After install the system the car would not start.   So I re-gapped the Pertronix and still it  wouldn’t start.   I was sure I didn’t screw up the firing order when I put the new cap on, but I pulled out the book and rechecked.  Not the problem.

So I went about putting the points and condenser back in and it still didn’t fire up, put the old coil back on and still no luck.  I put the Pertronix back in and of course the beast would not fire up.

This video covers it.

If you read the previous post and watched the video, you would have noticed gas seeping from a crack in the rubber line just above the “steam punk” fuel pressure gauge and the collection of hose clams.  Truly a work of art – no doubt, but totally a mess.

Ye,s I should have looked that over better and replaced it prior running the car.  However, it’s better now and a solid temporarily fix.  Here a clip.

Again, this is a temp fix and a proper line will be installed eventually.

Here’s a wrenching tip:  When install hose clamps on a gas line, be sure you’ve tighten them all before your start the car.  Gas has a tendency to not flow in the desired direction, when not well contained.  Yeah…gas everywhere and not just a little.   Here’s garage tip:  Cat Litter – buckets full!!!  ‘nough said!!!

Thanks for reading and as always….let me hear from you.

Tim

#ProjectSportsRoof